McDATA OPENconnectors Command Line Interace Bedienungsanleitung PDF herunterladen (Seite 318)

100

101

A-16

E/OS Command Line Interface User Manual

Message Error 110: Invalid Percent Utilization

Description The type of the throughput threshold alert has not been set.

Action Set the type of the TTA, then try to activate the alert.

Message Error 111: Invalid Threshold Type

Description The type of the threshold alert is not valid.

Action Configure the type of the throughput threshold alert to one of the

types found in the enumerated table for TTAs.

Message Error 112: No Threshold Definition Given

Description The threshold value for the alert was not configured before the user

attempted to activate the alert.

Action Set the threshold value, then try to activate the alert.

Message Error 115: Invalid Switch Speed

Description The request cannot be completed because the switch is not capable of

operating at the configured speed.

Action Consult the installation/service manual to determine the speed

capabilities of your product.

Message Error 116: Switch Not Capable of 2 Gb/sec

Description The request cannot be completed because the switch is not capable of

operating at 2 Gb/sec.

Action Consult the installation/service manual to determine the speed

capabilities of your product.

Message Error 117: Port Speeds Cannot be Set at Higher Data Rate than

Switch Speed

1 2 ... 313 314 315 316 317 318 319 320 321 322 323 ... 405 406

Kommentare zu diesen Handbüchern

Keine Kommentare

McDATA OPENconnectors Command Line Interace Bedienungsanleitung Seite 318

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung McDATA OPENconnectors Command Line Interace