McDATA Eclipse 2640 SAN Wartungshandbuch PDF herunterladen (Seite 46)

2-10

McDATA Eclipse 2640 SAN Router Installation and Service Manual

• At the command prompt enter:

set mgmt permroute <addr><mask><gateway>

where:

address = IP address of the network management subnet. This IP

address is used to add a static route to the SAN Router’s route

table. This is required by the management station if its on a

different subnet than the 10/100 interface.

mask = subnet mask of the network management subnet.

gateway = IP address of the gateway router. The gateway router

is a directly connected router to which management traffic should

be forwarded.

5. Save the configuration using the CLI:

• At the command prompt enter:

save

6. Reset the system using the CLI:

• At the command prompt enter:

reset system

The management IP address is now set and ready for normal

out-of-band management. If you choose to continue configuring the

SAN Router using CLI, please see the McDATA Enterprise Operating

System/Internetworking (E/OSi) Command Line Interface User Manual.

Task 7: Initiating the Element Manager

1. Connect the standard RJ45 Cat 5 Ethernet cable from the LAN to

the 10/100 management port (RJ45). See

Figure 2-2, on page 2-8.

• Wait for the SAN Router to come up (watch for the link LED to

light).

NOTE: The link LED is located next to the RJ45 connector. A steady light

means the port is active and a blinking light means there is traffic.

2. Ping the IP address you entered in Task 6 to verify network

connectivity using the network management host.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 101 102

Keine Kommentare

McDATA Eclipse 2640 SAN Wartungshandbuch Seite 46