McDATA Sphereon 4500 Bedienungsanleitung PDF herunterladen (Seite 147)

Reset Configuration

5-9

Using Maintenance Features

using this option, record the switch’s current IP address which

displays below the switch’s icon in the EFC Manager’s Product View

(view Display Options set to Network Address). You can also find the

current IP address through the SANpilot Interface.

After resetting the configuration, you must reset the original address

on the switch through the maintenance port or the SANpilot Interface

to maintain LAN connections and communication with the service

processor.

Procedure

1. Set the switch offline. For instructions, refer to Set Online State on

page 5-4.

2. Select Reset Configuration from the Maintenance menu on the

menu bar. The following warning displays:

WARNING

This operation will reset all switch configuration data and

non-volatile settings to factory default values. All optional

features will also be disabled. The switch must be offline to

continue.

If you have enabled features that add additional port function since the

switch was shipped from the factory, these features will be disabled (factory

default) when the configuration is reset. Only those ports that were enabled

at the factory will function. You will have to enable the additional port

function features again through the Configure Feature Key dialog box.

Factory-default values may vary, depending on the firmware release installed

in your switch. For a list of values, refer to the MCDATA Sphereon 4500 Fabric

Switch Installation and Service Manual (620-000159).

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 215 216

Keine Kommentare

McDATA Sphereon 4500 Bedienungsanleitung Seite 147